Sauder Englewood 426918 Manual De Instrucciones página 36

Step 30
1
D87
K
Groove
å
Insert the FILE DRAWER SIDES (D87 and D88)
at an angle into the slot at each end of the FILE
DRAWER FRONT (K).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the FILE DRAWER BACK (D78) to the FILE DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the FILE DRAWER BACK (D78).
Page 36
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the FILE DRAWER BOTTOM (D708) into the
grooves in the FILE DRAWER SIDES (D87 and D88) and
FILE DRAWER FRONT (K).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
426918
With the palm of
your hand, tap
the DRAWER
BOTTOM down
U n fi
n i s h
into the groove.
s u r
e d
f a c
e
D708
D87
D88
K
30S
(4 used in this step)
www.sauder.com/service
9