Sauder Englewood 426918 Manual De Instrucciones página 31

Step 25
å
Carefully stand your unit upright.
å
Push the DOOR STOP (4I) into the hole in the LEFT UPRIGHT (C).
å
Before fastening the DOOR to your unit, be sure the mounting
screw is against the stops as shown in the right diagram. If it isn't,
loosen the adjusting screw and mounting screw to slide it against
the stops. Then tighten the mounting screw.
å
Fasten the DOOR (P) to the LEFT END (B) as shown in the lower
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
å
See the next step for DOOR adjustments.
B
www.sauder.com/service
C
P
4I
426918
17
Mounting
screw
Adjusting
screw
Hinge
The DOOR STOP is
adjustable. If needed, turn the
DOOR STOP left or right until
it extends slightly past the
front edge of the UPRIGHT.
Stop
Page 31