Descargar Imprimir esta página

Kemper 79 002 Instrucciones De Servicio página 78

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 186
Fig. 42: Fixing the extraction hose to the extraction hood
Pos.
Description
2
Rubber sleeve
3
Hose clamp
4
Suction tube
Tab. 44: Fixing the extraction hose to the extraction hood
11. Pull the end of the hose (Pos. 4) over the connection piece of the
extraction hood (Pos. 8) as shown in the illustration and fix it with the
hose clamp (Pos. 3).
12. Then cover the hose clamp (Pos. 3) and the revolving joint (Pos. 8.5) with
the rubber sleeve (Pos. 2).
NOTE
The ease of the joint is preset at the factory. If readjustment is still
necessary, then only use the screws in the joint points with plate springs.
When properly adjusted, the position of the extraction arm is held almost
exclusively by the force of the spiral springs.
5.5 Mounting the extraction hood with lighting - optional
The following chapters describe the assembly and cable routing of the
extraction hood with lighting.
1502759-03
Pos.
Description
8
Extraction hood
8.5
Revolving joint
- 78 -
EN

Publicidad

loading