Kemper 79 002 Instrucciones De Servicio página 87

7 Maintenance
The instructions in this chapter are intended as minimum requirements.
Depending on the operating conditions, further instructions may be
required to keep the product in optimal condition.
The maintenance and repair work described in this chapter must only be
performed by specially trained repair personnel of the operating company.
Spare parts used must comply with the manufacturer's specified technical
requirements.
This is guaranteed if original spare parts are used.
The safe and environmentally friendly disposal of operating materials and
replacement parts must be ensured.
The safety instructions in these operating instructions must be observed
during maintenance work.
7.1 Care
The care of the product is essentially limited to cleaning all surfaces of the
product and – if present – checking the filter inserts.
The warning notices listed in the chapter "safety notes for maintenance
and fault removal on the product" must be observed.
NOTE
The product may not be cleaned with compressed air. This may result in
dust and/or dirt particles getting into the ambient air.
Proper care helps to maintain the product in a continuous functional state.
• The product must be cleaned once a month.
• The exterior areas of the product can be cleaned with a suitable
industrial vacuum cleaner of dust classification H or alternatively wiped
with a wet cloth.
7.2 Maintenance
Regular inspection and servicing have a positive effect on the reliable
functioning of the product and should be done at least once a month.
Please observe the listed warning notices for maintenance listed in chapter
"safety".
1502759-03 - 87 -
EN