Genesis GLSS08B Manual Del Operario página 8

USING SCISSORS (FIG 4)
• To start the cutting action, slide the lockoff switch (2)
back, while at the same time pulling the on/off switch up.
• Place the blades on the material to be cut and slowly
guide forward to make the cut.
CUTTING HEAD SELECTION (FIG 5)
The scissors come with two cutting heads:
55° cutting head (3) with "O" shaped indicator on the upper blade is the best for soft materials such as fabric,
carpet, thin cardboard and EVA foam.
75° cutting head (4) with "D" shaped indicator on the upper blade is the best for cutting hard materials such
as clamshell, thin soft metal sheets (tin, brass, copper), plastic sheet, and thick cardboard.
When Using the Cutting Head with "O" Shaped
Indicator to Cut Soft Materials
Materials
Cotton fabrics
Felt
Carpet (Backing)
Vinyl flooring
Corrugated Cardboard
Solid Cardboard
When Using the Cutting Head with "D" Shaped
Indicator to Cut Hard Materials
Materials
Hard Plastic (Sheets)
Soft Metal Sheets (Tin. Brass, Copper)
CHANGING CUTTING HEAD (FIG 6)
• To change the cutting head, slide and hold the head lock (10) away
from the cutting head. Push the buttons (9) on both sides of the
installed cutting head.
• Pull the cutting head forward to remove.
• To install cutting head, slide it onto the front of scissors until the
lock clicks.
8
Maximum Cutting
Thickness
2.5 mm
6.0 mm
3.5 mm
3.5 mm
3.5 mm
1.8 mm
Maximum Cutting
Thickness
1.0 mm
0.2 mm
8V Cordless Power Scissors
Operator's Manual
2
3
4
FIG 5
10
9
GLSS08B
FIG 4
FIG 6