Stihl FS 130 Manual De Instrucciones página 30

Removing Mounting Hardware
:
Block the shaft – see next section
on "Blocking the Output Shaft".
:
Use the combination wrench (6)
(supplied with machine or available
as special accessory) to unscrew
the nut (3) clockwise (left-hand
thread) from the shaft (2).
:
Pull the thrust washer (5) off the
shaft (2).
FS 130, FS 130 R
The rider plate (4) is in the parts kit
supplied with the machine.
:
Go to "Mounting the Mowing Head"
or "Mounting Metal Cutting Tools".
Blocking the Output Shaft
2
8
7
:
Insert the stop pin or screwdriver (7)
(supplied with machine or available
as special accessories) in the hole
(8) in the gearhead as far as stop –
apply slight pressure.
:
Rotate nut or cutting tool on the
shaft (2) until the stop pin slips into
position and blocks the shaft.
7
Mounting the mowing head
Keep instruction sheet for mowing head
in a safe place
:
Screw the
STIHL SuperCut 20-2,
STIHL AutoCut 25-2, 30-2
STIHL TrimCut 30-2 or
STIHL PolyCut 20-3
counterclockwise onto the shaft (1)
as far as stop.
:
Block the output shaft.
:
Tighten down the mowing head.
Remove the stop pin
English / USA
1
.
29