Storing The Machine; Sharpening Metal Cutting Tools - Stihl FS 130 Manual De Instrucciones

Storing the Machine

For periods of about 3 months or longer
:
Drain and clean the fuel tank in a
well ventilated area.
:
Dispose fuel properly in accordance
with local environmental
requirements.
:
Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
:
Remove, clean and inspect the
cutting tool.
:
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
:
Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
FS 130, FS 130 R
Sharpening
Metal Cutting Tools
:
Use a file (special accessory) to
sharpen cutting tools. In case of
more serious wear or nicks:
Resharpen with a grinder or have
work done by STIHL dealer.
:
Resharpen frequently, take away as
little material as possible – two or
three strokes of the file are usually
enough.
To avoid out-of-balance
:
After resharpening about 5 times,
have blade checked on STIHL
balancer (special accessory) and
rebalanced as necessary.
English / USA
1
2
1
2
:
Resharpen the cutters (1) uniformly
– do not alter the contour of the
parent blade (2) in any way.
See cutting tool packaging for additional
sharpening instructions.
1
2
47