Parkside PTBM 400 A1 Traducción Del Manual De Instrucciones Original página 23

Intended purpose
The bench drill is designed for drilling in
metal, wood, plastic and tiles. Straight
shank drills with a drilling diameter from
1.5 mm to 13 mm can be used.
The device is intended to be used by do-it-
yourselfers. It was not designed for heavy
commercial use.
The tool is not to be used by persons.
under the age of 16. Children over the
age of 16 may use the tool except under
supervision.
The manufacturer is not liable for damage
caused by an improper use or incorrect
operation of this device.
General description
An illustration of the most im-
portant functional components
can be found on the front and
the back fold-out pages.
Extent of the delivery
Carefully unpack the appliance and check
that it is complete. Dispose of the pa
ckaging material correctly.
- Baseplate
- Drilling bench
- Column tube
- Motor unit
- 3 drill lifting arms
- Safety device
- Drill chuck
- Drill chuck key
- Allen key
- Vice
- Laser
- 2 x 1.5 V batteries, AAA size
- 5x assembly screws
2x nuts
4x washers
2x spring washers
- Instruction Manual
Description of functions
Please refer to the descriptions below for
information about the operating devices.
Overview
1 Gear cover
A
2 Holder for drill chuck key and
Allen key
3 Locking screw for gear cover
4 Locking nut for motor unit
5 Motor unit
6 Column tube
7 Locking handle
8 3 Assembly screws
9 Baseplate
10 Retaining screw for drilling
bench inclination
11 Mounting screws for vice
12 Drilling bench
13 Vice
14 Chuck jaws
15 Angle scaling
16 Clamping screws for motor unit
17 Battery compartment, laser
18 Laser controller
19 Clamping screw
for safety device
20 Drill spindle
21 Drill chuck
22 Drill lifting arm
23 Safety device
24 Emergency stop switch
25 Hand spindle guide
26 Cover, emergency stop switch
27 Off switch
28 On switch
29 Depth stop with scale
30 Locking screw of the depth stop
GB IE
23