Publicidad
Idiomas disponibles
Idiomas disponibles
EN
The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Push the lock button and turn the lower shaft 90° or 180°
until it engages.
3. Release the lock button.
4.6
OPERATION TIPS
Figure 10.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
•
Keep the machine connected to the correctly worn
harness.
•
Keep a firm hold with the two hands on the machine
while you operate the machine.
•
Cut tall grass from the top down.
If grass winds around the trimmer head:
•
Remove the battery pack.
•
Remove the grass.
4.7
CUTTING TIPS
Figure 11.
•
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
•
Move the machine from right to left to prevent thrown
debris toward the operator.
•
Do not cut in dangerous areas.
•
Do not force the trimmer head into uncut grass.
•
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
4.8
LINE CUT-OFF BLADE
Figure 12.
This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
NOTE
WARNING
WARNING
English
4.9
ADJUST THE CUTTING
DIAMETER
Figure 12.
The machine is set at a 9 in (229 mm) cutting diameter. You
can adjust to a 11 in (279 mm) cutting diameter.
Set the cutting diameter to 9 in (229 mm) for greater
runtime and 11 in (279 mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
5
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
5.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
5.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
6
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
Publicidad
