Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
1. In order to carry out safe and proper instal-
lation of the product, please read this book-
let carefully beforehand and follow the in-
structions contained within.
2. On completion of the installation, start the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the Instruc-
tion Manual.
3. This booklet should be handed over to the
user after the installation and be preserved
by the user together with the Instruction
Manual for any further consultation that may
be necessary.
WARNING
WARNING
WARNING
WARNING
WARNING
The installation must be carried out by qualified
The installation must be carried out by qualified
The installation must be carried out by qualified
The installation must be carried out by qualified
The installation must be carried out by qualified
personnel,
personnel,
personnel,
personnel, in accordance with current regulations,
personnel,
according to the manufacturer's instructions.
1. UNPACKING
1. UNPACKING
1. UNPACKING
1. UNPACKING
1. UNPACKING
WARNING
WARNING
WARNING
WARNING
WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
Remove shipping carton, tape(s) and packing. If
packing material is left in the icemaker, it will not
work properly.
1) After removing the packaging, make sure that the
icemaker is in good condition. If in doubt, please
do not use the equipment but apply to professionally
qualified personnel.
2) Remove the top and front panels to prevent damage
when installing the icemaker. (See "2. HOW TO
REMOVE PANELS.")
3) Remove the package containing the accessories
from inside the Bin.
4) Remove the protective plastic film from the panels. If
the icemaker is exposed to the sun or to heat, remove
the film after the icemaker cools.
5) Check that the refrigerant lines do not rub or touch
lines or other surfaces, and that the fan blade turns
freely.
All manuals and user guides at all-guides.com
2
6) Check that the Compressor is snug on all mounting
pads.
7) See the Nameplate on the Rear Panel, and check that
your voltage supplied corresponds with the voltage
specified on the Nameplate.
8) Remove the shipping tapes securing the Cube Guide.
2. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1
Fig. 1
Fig. 1
Fig. 1
Fig. 1
Fig. 1
a) Top Panel . . . . . . Remove the two screws and lift
off.
b) Front Panel . . . . . Remove the two screws, lift up
and toward you.
3. LOCATION
3. LOCATION
3. LOCATION
3. LOCATION
3. LOCATION
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient tempera-
ture should be within +7°C to +40°C. Normal
operating water temperature should be
within +7°C to +35°C. Operation of the
icemaker, for extended periods, outside of
these normal temperature ranges may af-
fect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
91U1TB10A9907
Publicidad
