Inductive Conductivity Sensors; Safety Information; Use Of Hazard Information - Hach 8398 serie Manual Del Usuario

Specification
Measurement range
Temperature
response
Maximum
temperature
Maximum pressure
Sample connection

1.2 Inductive conductivity sensors

Specification
Application
Material
Cell constant K
Accuracy
Measurement range
Conductivity response
Temperature response
Maximum pressure
Maximum temperature
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

2.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

2.1.1 Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
4 English
8315
-1
0.01—200 μS.cm 0.1 μS—2 mS.cm
< 30 seconds
150 °C
25 bars
¾ inch NPT
Corrosive and fouling applications
0—2000 mS/cm
8316
-1
1 μS—20 mS.cm
< 30 seconds < 30 seconds
150 °C
25 bars
¾ inch NPT
8398 series
PEEK
-1
2.35 (cm )
± 2 %
< 1 second
< 2 minutes
18 bars
140 °C
N O T I C E
D A N G E R
8317
-1
0.01—200 μS.cm
< 30 seconds
150 °C
25 bars
Tri-Clamp 1½ or
¾ inch NPT
8332
Measurement in harsh conditions
PVDF
-1
10 (cm
± 2 %
100 μS/cm—10 S/cm
< 1 second
< 2 minutes
7.5 bars
120 °C
8394
-1
150 °C
25 bars
2 inch
)