Kenmore KW3010 Manual De Uso Y Cuidado página 11

INSTALLING & CLEANING PRE-FILTER
INSTALLING PRE-FILTER
1. Verify that the power cord is
disconnected from the outlet.
2. Remove the powerhead and place in an
upside-down position.
3. Install the pre-filter onto the rim of the
collection tank. Make sure the edge of
the filter fits snugly along the edge of
the collection tank.
NOTE: Ensure the dust bag and the pre-
filter are correctly installed before each
use.
REMOVING & CLEANING THE AIR INLET FILTER
1. Verify that the power cord is
disconnected from the outlet.
4. Place the powerhead back onto the
collection tank.
REMOVING & CLEANING PRE-FILTER
1. Remove the pre-filter by lifting up.
2. Clean the pre-filter by gently tapping
or brushing dirt off. If necessary, gently
rinse the pre-filter with cool clean
water. Do not scrub or brush the pre-
filter. Allow the pre-filter to air dry for
24 hours before re-installing. DO NOT
install pre-filter if it is damp, or it will
damage the vacuum.
3. For optimal performance, it is
recommended to replace the pre-filter
every 3 to 6 months.
4. Install cleaned or new filters as above in
steps 2-4 of Installing Pre-Filter.
2. With the removed powerhead in an
upside-down position, carefully remove
the air inlet filter from the tabs.
- 11 -
Air Inlet Filter