PROBLEM
The power cord is stuck.
The power
The cord is being winded in the
cord cannot be
wrong direction.
retracted.
Retract the power cord too fast.
Dust bag is full.
Suction nozzle, hose, or tank inlet
is blocked.
Reduced
The pre-filter or air inlet filter
efficiency and
needs to be cleaned.
motor/speed
vibration.
The accessories such as hose, floor
nozzle and extension wand or the
powerhead are not installed into
place, causing air leakage.
TROUBLESHOOTING
POSSIBLE CAUSE
Release the power cord and retract it again.
Wind in the direction the arrow is pointing.
Retract the power cord slowly.
Replace the dust bag.
Check the suction nozzle, hose, and tank inlet
for obstructions.
Check and clean the pre-filter and air inlet
filter. Replace if damaged.
Install each part correctly.
- 15 -
SOLUTION