Emos P5760 Manual De Instrucciones página 5

All paired receivers are in parallel connection.
It is thus necessary that each paired receiver is powered throughout for the repeater function to work properly.
Deactivating Repeater Mode
Switch the button to position O on the chosen receiver.
The receiver will not forward signal to other paired receivers in the line upon ringing – the receivers after it
will not ring.
Installation of the Doorchime (Transmitter) Button
1. Begin by pairing the button with the chime.
2. Before installation, verify the reliable functioning of the set in the chosen spot.
3. Remove the rear cover with a screwdriver through a hole on the side of the button.
4. Use the double sided adhesive tape (included) or two screws to fix the rear portion of the cover to the wall.
Although the button is weather resistant, choose a location where it is protected, e.g. in a wall recess.
5. Re-assemble the button.
6. Press the button to ring the chime. Pressing is accompanied by LED illumination indicating the button has
sent a radio signal. The chime plays the selected melody.
Note: The doorchime button (transmitter) can be placed on wood or brick walls without issue. However, never
place the button directly onto metal objects or materials containing metal, such as plastic window or door
structures that have a metal frame. In such cases, the transmitter will not work properly.
Installing the Chime (Receiver)
1. The chime is intended for indoor use only. When running, it must be plugged in a 230 V AC/50 Hz socket
and with free space around it so that it is always accessible.
2. The transmission range (max. 120 m) is influenced by local conditions, such as the number of walls through
which the signal passes, metal door frames and other elements which affect the transmission of radio
signals (presence of other radio devices operating at a similar frequency, such as wireless thermometers,
gate controls etc.). The transmission range can decrease drastically due to these factors.
Troubleshooting
The chime is not ringing:
• The chime may be out of range.
− Change the distance between the button and the chime; the range may be affected by local conditions.
• The chime battery may be flat.
− Replace the battery. Make sure it has the correct polarity. Pair the button with the chime again.
• The chime is not powered.
− Make sure the chime is properly inserted in the socket and that the power is running or the fuse/
circuit breaker for the electric network section is on.
Upkeep and Maintenance
The wireless digital doorchime is a sensitive electronic device. Therefore, it is necessary to observe the
following precautions:
• The chime (receiver) is designed for interior use in dry environments only.
• The chime must be located in an easily accessible location for ease of handling and unplugging.
• Periodically check the functionality of the doorchime button and replace the battery in time. Use only
quality alkaline batteries with the prescribed parameters.
5