Descargar Imprimir esta página

Stihl HTA 135 Manual De Instrucciones página 35

Ocultar thumbs Ver también para HTA 135:

Publicidad

Idiomas disponibles

Idiomas disponibles

14 Assembling the Pole Pruner
WARNING
Never use waste oil to lubricate your saw chain and guide
bar. Repeated contact with waste oil can cause skin cancer.
Moreover, waste oil is environmentally harmful.
Bar and chain oil lubricates and cools the rotating saw chain.
The service life of the chain and guide bar depends on the
quality of the lubricant. It is therefore essential to use only a
specially formulated chain lubricant.
► For automatic and reliable lubrication of the chain and
guide bar, use only an environmentally compatible quality
chain and bar lubricant. STIHL recommends using rapidly
biodegradable STIHL BioPlus.
NOTICE
Biodegradable chain oil must be resistant to aging, since it
will otherwise quickly turn to resin. This results in hard
deposits that are difficult to remove, especially in the area of
the chain drive and chain. It may even cause the oil pump to
seize.
NOTICE
Waste oil does not have the necessary lubricating properties
and is unsuitable for chain lubrication.
14.8.2 Filling the Chain Oil Tank
Opening and Filling the Chain Oil Tank
To fill the chain oil tank:
► Switch off the pole pruner, @ 16.2.
► Remove the battery, @ 15.2.
► Position the pole pruner on a level surface with the oil filler
cap facing upwards.
► Clean the area around the oil filler cap with a slightly
dampened cloth.
0458-698-8621-A
1
2
► Flip up the grip and press the cap down firmly (1).
► Turn the cap slowly counter-clockwise (2) to the open
position (3). In the open position, the exterior positioning
mark (4) on the cap will line up with the symbol (5) on the
chain oil tank housing
► Remove the cap and fill the tank with bar and chain oil.
► Take care not to spill bar and chain oil while refilling the
tank.
► Do not overfill the tank. Leave approximately 0.5 in.
(13 mm) of air space.
Closing
To close the tank:
1
2
► Raise the grip on the top of the cap until it is upright at a
90° angle. Insert the cap in the chain oil tank opening with
the exterior positioning mark (1) lined up with the open
symbol (2) on the chain oil tank housing.
English
3
4
5
4
1
3
33

Publicidad

loading