Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
INSTALLING FLEXIBLE SHAFT
1. Remove the bolt and insert the outer fi tting (with o-ring)
into the joint pipe, and tighten the bolt. And also add a
small amount of grease to the O-ring, before attaching.
2. Insert the outer fi tting into the clutch drum housing with
pulling up the Pin. Be sure pin returns to original position
by spring and outer fi tting never comes off from clutch
drum housing.
STOP SWITCH WIRING
1. Remove the air fi lter cover.
2. Plug the stop switch wires into the matching connectors from the
engine. Note that wire polarity is not important.
3. Lap and fi x the stop switch wires and connectors with clamp.
THROTTLE CABLE WIRING
The cable lug must be inserted into and through the cable
adjuster sleeve held by the bracket on top of the carburetor.
Make sure the end of the cable housing is seated positively in
the sleeve. The cable lug fi ts into the slotted fi tting as shown.
A HOLE IS PROVIDED FOR THE LUG AT ONE END OF THE
SLOT.
Operate the throttle trigger a few times to make sure that it
works correctly.
Adjust the cable adjuster sleeve so the cable position keep
1-2mm play between cable lug and slotted fi ttings when the
throttle trigger is fully depressed. When the throttle cable is
adjusted correctly, tighten the lock nut.
Outer Fitting
Stop Switch Wires
＿ US-3 ＿
grease
Bolt
Joint Pipe
Pin
Clutch Axis
Inner Shaft
Clutch Drum Housing
Throttle Cable Housing
Cable Adjuster Sleeve
Throttle Cable
Lock Nut
Carburetor
Bracket
1-2mm Play
Outer
O-ring
Clamp
Slotted Fitting
Cable Lug
Recessed Hole
Publicidad
