Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two stroke engines used in the brushcutter requires a mixture of GASOLINE and OIL for lubrication of
bearings and other moving parts. See the chart below.
Fuel Mixture Chart
Gasoline
ISO-L-EGC/ EGD ,JASO class FC/ FD,
or equivalent two-stroke oil
1 liter
2 liters
5 liters
NOTE : Gasoline and oil must be premixed in a clean gasoline container. Never mix gasoline and oil
indoors or in the burushcutter fuel tank. Always use fresh gasoline.
Do not use the old fuel more than 1 month.
WARNING !! - NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before filling the brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter
the fuel tank. Always shake the fuel container before filling the fuel tank. Remove the fuel cap, then fill the
fuel tank to within about 10mm from the top of the tank. Avoid filling the fuel tank filler neck. Install the cap
securely onto the fuel tank.
OPERATING INSTRUCTIONS
Starting and Stopping
COLD STARTING PROCEDURE
This engine is equipped with a fuel primer and a choke system. To start a "cold" engine properly, perform
the following procedure:
1. Pump the primer bulb at the bottom of the carburetor until fuel can be seen flowing through the fuel return
line to the fuel tank. (Flowing fuel should be almost clear, not foamy or full of bubbles.)
2. Move the choke lever to the closed (
3. Lock the throttle trigger in the fast-idle start position, then pull the starter grip.
4. After the engine starts, squeeze and release the throttle trigger to return it to the idle position, then move
the choke lever to the open (
If the engine stops running before you move the choke lever to the open (
Go ahead and open the choke, pull the starter grip with the throttle trigger positioned at Fast-idle position.
Choke Lever
Primer
Bulb
Two-stroke oil
50:1
20 mL
40 mL
100 mL
) position and move the stop switch to the "START" (ON) position..
) position.
Fuel Return Line
Starter Grip
＿ US-6 ＿
25:1
ISO-L-EGB , JASO class FB,
or equivalent two-stroke oil
40 mL
80 mL
200 mL
) position:
Fast-idle Start Lock
STOP (OFF)
Stop Switch
START (ON)
Fast-idle Start
Position
Idle Position
Publicidad
