MUCAR CS2 Manual Del Usuario página 15

will go out and the system will start a new maintenance cycle.
5.2.2 Brake Pad Reset (EPB)
When the brake pad reaches certain thickness, the brake pad induction wire will be worn.
At this time, the wire will send a signal induction wire to the on-board computer to prompt
the replacement of the brake pad. After replacing the brake pad, the brake pad need to be
reset, otherwise the car will continue to alarm. Situations when the reset is required:
a) After the brake pad is replaced and when brake pad wears sensors;
b) When the brake pad indicator lightens;
c) After the brake pad sensor circuit is repaired;
d) After the servo motor is replaced.
5.2.3 Tire Pressure Reset (TPMS)
When the car tire pressure fault indicator light is on, this function is to reset the tire
pressure and turn off the tire pressure fault indicator.
If the tire pressure is too low or leaks, replace or install tire pressure monitoring equipment,
and replace the tire. When the vehicle with a damaged tire pressure sensor and tire
pressure monitoring function has rotated its tires, the tire pressure reset must be carried
out after maintenance.
5.3 File
It is used to record and establish the file of the diagnosed vehicles. The file is created
based on the vehicle VIN and check time, including all diagnostic-related data such as
diagnostic reports, data stream records and screenshots.
21
www.mucarco.com
www.mucarco.com
5.4 Repair Info
It includes 4 items, namely, a fault code data base, a table of vehicles able to be
diagnosed, videos, a learning course. The maintenance technician can quickly refer to
the explanation of the fault codes, and understand all the vehicles that can be diagnosed
through the table. The videos contain equipment usage guides, maintenance and
diagnosis guides. The learning course demonstrates how tools are operated. These
four functions help technicians quickly grasp the equipment use and improve diagnostic
efficiency.
5.5 Software update
This module allows you to update the diagnostic software & App and set frequently used
software.
If you did not download the software in process of product registration or a pop-up
message reminding you that some new software can be updated, you may use this option
to download it or keep it synchronized with the latest version.
5.6 Settings
The host uses system settings. After the initial setting is completed, the user can modify or
add related information here or swipe the screen from the top to make settings.
5.6.1 Customer management
Information of all clients whose vehicles have been diagnosed will be displayed here in
turn.
5.6.2 Network
Set the connectable WIFI network.
22