MUCAR CS2 Manual Del Usuario página 2

Safety Precautions and Warnings
To avoid personal injury, property loss, or accidental damage to the product, read all of the
information in this section before using the product.
Handle equipment carefully
Do not drop, bend, or puncture the tool, or insert extra objects into or place heavy objects
on the device. The vulnerable components inside may be damaged.
Do not disassemble or modify the equipment
The device is a sealed device with no user-serviceable parts inside. All internal repairs
must be performed by an authorized maintenance organization or qualified technician.
Attempts to disassemble or modify the device will void the warranty.
Do not try to replace the internal battery
The internal rechargeable lithium battery must be replaced by an authorized maintenance
organization or qualified technician. Contact the dealer for factory replacement.
Adapter information
Avoid immersing the device in water or placing it in a location where it may absorb moisture or
other liquids.
During normal use, the charging device may become hot. Please ensure that there is good
ventilation while charging device.
If any of the following situation occurs, please unplug the charging device:
• The charging device is exposed to rain, liquid or in an environment with excessive
overlap.
• The charging device showed physical damage.
• The charging device is under cleaning.
Data and Software Protection
Do not delete unknown files or change the names of files or directories created by others,
otherwise the device software may not run.
！ Note: Access to network resources makes the device vulnerable to computer viruses, hackers,
spyware, and other malicious behaviors, and may damage the device, software, or data. To make
ensure that you are using firewalls, anti-virus software and anti-spyware software to provide
adequate protection for your computer and keep these software up to date.
Precautions on Using this tool
• Make sure the ignition switch should be in the OFF position when plugging and
unplugging the diagnostic connector.
B
www.mucarco.com
www.mucarco.com
• Keep the connector in the storage box on the back of the main unit, when the vehicle
diagnosis is finished.
• Gently press the diagnostic connector to pop up the diagnostic connector. Do not pull or
use sharp objects to pry the diagnostic connector.
Precautions on Operating Vehicle's ECU
• Do not disconnect battery or any wiring cables in the vehicle when the ignition switch is
on, as this could avoid damage to the sensors or the ECU.
• Do not place any magnetic objects near the ECU. Disconnect the power supply to the
ECU before performing any welding operations on the vehicle.
• Be extremely careful when performing any operations near the ECU or sensors. Ground
yourself when you disassemble PROM, otherwise ECU and sensors can be damaged
by static electricity.
• When reconnecting the ECU harness connector, make sure it is attached firmly,
otherwise electronic elements, such as ICs inside the ECU, can be damaged.
C