BGS technic 1689 Manual De Instrucciones página 15

Idiomas disponibles

RAM SETUP

Note: When positioning the Ram (B) use a smaller attachment on the side that is to be bent instead

of the stationary side. lf the stationary side is in danger of being bent or damaged, place a block of

wood or other material behind the Flat Base (3) to distribute pressure over a greater area.

When extension tubes and/or offset attachments are used, the rated capacity is always reduced by

50% for each tube or offset attachment connected.

1. Clean the end of the Hose (21) and the inlet on the Ram (B). Unscrew and save the Dust

Covers located on the end of the Hose (21) and Ram (B).

2. Attach the Hose to the Ram.

3. Assemble attachments as shown below:

A PUSH & STRETCH

B SPREAD

Vertical Spread

BGS technic KG

Bandwirkerstr. 3

D-42929 Wermelskirchen

Vertical Push

Horizontal Stretch with Extensions

Note: If using the Flange Base and the Flange

Head, thread the Flange Base onto the Ram

completely and align the Flange Head to it.

Tel.: 02196 720480

Fax.: 02196 7204820

mail@bgs-technic.de

Horizontal Push

Spread

0.5 Ton

Hydraulic Spreader

www.bgstechnic.com