Sunoptic Surgical LED-4000 Manual Del Operador página 12

8.3 Repair
You may return your product(s) for repair, shipping prepaid to the factory. Your product will be
inspected, and an estimate of repair charges will be submitted to you for approval.
PHONE: +1 (877) 677-2832
FAX: +1 (904) 733-4832
8.4 Troubleshooting
Problem
Main switch power indicator
(refer to 5) is not lit when
switched on.
The power indicator is lit but
the main LED is still off.
9. END OF PRODUCT LIFE
In accordance with the European Waste from Electrical and Electronic Equipment (WEEE) directive,
we encourage our customers to recycle this product whenever possible. Disposal of this unit must be
performed in accordance with the applicable local environmental regulations.
In the US, a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to manufacturer at the
end of product life.
10. SYMBOLOGY
LIT-216 Sunoptic Surgical
Rev. E
INTERNATIONAL: +1 (904) 737-7611
Check that the AC power cord is properly connected to an
energized circuit and the device AC receptical.
Check the unit fuses and replace if necessary.
Contact customer service.
Press Stand-By switch to turn on the LED.
Check that the light guide is inserted in the active turret port
(top).
Increase the LED intensity.
Contact customer service.
Manufacturer
Date of manufacture
(YYYY-MM-DD)
Symbol for Authorized Representative in the European
Community
Caution, consult accompanying documents
Consult Instructions for Use
CE mark
Do not use if package is damaged.
Not for disposal in general waste
Medical device
®
Page 12 of 114
Solutions
(English)