Dremel US40 Instrucciones De Funcionamiento Y Seguridad página 12

2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 12
Thank you for purchasing the Dremel US40.
This tool was designed to tackle a wide variety
of projects in and around the home. The
Dremel US40 completes tasks quicker and
more efficiently than a series of other tools that
would be needed to complete a job or project.
This tool is also compact, ergonomic, and cuts
virtually all common materials.
After using your new Dremel US40 you'll find
that it is the right size tool to get projects done
at just a fraction of the size of a traditional
circular saw. With a full line of accessories the
tool cuts through virtually any common material
in the home- wood, plastic, metal, drywall and
tile. The tool also features two cutting wheel
positions, one position using a standard flat
tool, since torque from the motor can cause the
tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is under
load; this will greatly decrease the switch life.
PADDLE SWITCH WITH
"LOCK-OFF" FEATURE
The Paddle switch enables the operator to
control the switch functions of "Lock-OFF",
and "ON/OFF".
TO UNLOCK SWITCH AND TURN TOOL
"ON": Push "Lock-OFF" switch release lever
forward to unlock paddle switch, then squeeze
paddle switch (Fig. 8).
TO SWITCH TOOL "OFF": Release pressure
on paddle lever. The switch is spring loaded
and will return to "OFF" position automatically
(Fig. 8).
"LOCK-ON" BUTTON
The "Lock-ON" feature, incorporated into the
paddle switch, is a convenience for long
operations.
Introduction
Operating Instructions
Hold the tool with both
hands while starting the
wheel for all your typical straight cuts and a
second position for making flush cuts along
flooring or against a wall.
In addition to versatility, the Dremel US40
provides excellent line of sight for confident,
precise cuts so you will get accurate cuts the
first attempt and avoid wasting time or material.
Visit www.dremel.com to learn more about
what you can do with your new Dremel tool.
INTENDED USE
This Dremel US40 tool is intended for straight
cuts in wood, plastic, metal, drywall, fiberboard,
and tile using the applicable accessories
recommended by Dremel.
FIG. 8
Paddle
Switch
TO LOCK SWITCH "ON": After paddle switch
has been activated push "Lock-ON" button at
rear of tool completely in and release paddle
switch (Fig. 7).
TO SWITCH TOOL "OFF": Squeeze and
release paddle switch (Fig. 8).
In order to try to avoid recoil (a situation where
the wheel wants to skip out of the material) it
is recommended to make cuts in the same
direction as the rotation of the wheel.
and
section in this manual called "Kickback
and Related Warnings"
-12-
"Lock-ON"
Button
"Lock-OFF"
Switch Release
Lever
It is important to read
understand the