Dremel US40 Instrucciones De Funcionamiento Y Seguridad página 18

2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 18
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of
components which could cause serious
hazard. We recommend that all tool service
be performed by a Dremel Service Facility.
CARBON BRUSHES
The brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the
motor, we recommend that the brush es be
serviced by a Dremel Service Facility.
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
damage.
Store accessories in a dry and temperate environment to avoid corrosion and deterioration.
Metal Surface Prep Blade
US400
Non-woven abrasive wheel for heavy
rust removal and paint removal from metal.
Concrete Surface Prep Blade
US410
Diamond Embedded wheel for thinset
removal and paint removal from concrete and
brick.
Maintenance Information
Service
NO USER SERVICE -
ABLE PARTS INSIDE.
internal wires
Extension Cords
If an extension cord is
necessary, a cord with
Dremel US40 Accessories
Use only Dremel US40, high-performance accessories. Other accessories
are not designed for this tool and may lead to personal injury or property
tool from the power supply before
cleaning or performing any main tenance.
and The tool may be cleaned most effectively
with compressed dry air. Always wear
safety gog gles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia
detergents that contain ammonia.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50
3-6 18 16
6-8 18 16
8-10 18 16
10-12 16 16
12-16 14 12
Wood Carbide Wheel
US500
Abrasive cutting wheel with carbide grit
which is intended to cut wood and other soft
materials.
Metal Cut-off Wheel
US510
Reinforced Type 1A (ISO 41) Abrasive
cut-off wheel which is intended to cut a variety
of materials such as metal and plastic.
-18-
Cleaning
To avoid accidents
always dis connect the
Certain cleaning agents
and sol vents damage
and house hold
Wire Sizes in mm
Cord Length in Meters
100 150 15 30 60
16 14 0.75 0.75 1.5
14 12 0.75 1.0 2.5
14 12 0.75 1.0 2.5
14 12 1.0 2.5 4.0
– – – – –
2
120
2.5
4.0
4.0
–
–