2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 13
DEPTH ADJUSTMENT
FIG. 9
Disconnect plug from power source. Loosen
the depth adjustment lever located on the right
side of the tool. The foot is spring loaded and
will lower automatically (Fig. 9).
Tighten lever counter clockwise at the depth
setting desired. Check desired depth (Fig. 9).
Depth Adjustment
Lever
LINE GUIDE
The cutting guide notch will give an
FIG. 10
approximate line of cut (Fig. 10). Make sample
cuts in scrap lumber to verify actual line of cut.
Line Guide
-13-