Publicidad
IMPORTANT:
We recommend fi nishing the unit before fi nal assembly. Before fi nishing, read enclosed fi nishing hints.
NOTE: Due to the fact that more than one type of hardwood is used, we recommend testing for desired color.
To test for desired color on:
a) Veneer parts—apply stain to unexposed portion of side panel. See FIGURE 1A.
b) Alder pieces—apply stain to back of base. See FIGURE 6.
586Wb Palmer 6-Drawer Dresser
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Tape Measure, Hammer, Wood Glue, 3/16" Drill Bit and Drill.
FIG. 1A
Gb
V 2
V 2
V 2
STAIN TEST AREA
READ THE INSTRUCTIONS ON HOW TO OPERATE CAM LOCK SYSTEM ON THE
ENCLOSED SHEET AT THIS TIME.
1) Install three Drawer Slides (Cabinet Side Left) (V2) using #6 x 5/8" Undercut (type 17) Screws (R) in
the three sets of pre-punched holes in the Left Side (Gb). The slides should be fl ush with front edge
of the sides. Insert a third screw in one of the center holes in each of the slides. See FIGURE 1A.
Repeat for the Right Side (Hb) with Drawer Slides (Cabinet Side Right) (V1).
Hammer Tack Glides (Q) into the bottom edges of both sides about one inch from the back edge.
See FIGURE 1A.
Insert a Cam Connector (M) into each of the four holes in the bottom of the Top (J). See FIGURE 1B.
Page 4 — 586Wb — Rev. 6/07
R
R
R
R
R
R
Q
Q
The side panels have a
compression stamp on the
bottom edge:
Hb
"L" for left, "R" for right.
V1
M
V1
J
V1
The drawer slides will be stamped with an "L" for left or
an "R" for right in the center of the wheels. Or they will be
stamped about 3" from the wheel with: "CL" for cabinet
Left; "DL" for drawer left; "CR" for cabinet right; "DR" for
M
FIG. 1B
drawer right.
Publicidad
