Publicidad
R
V3
FIG. 8
8) Attach Drawer Slides (Drawer Side Left) (V4) and (Drawer Side Right) (V3) to the drawers. The
wheels should be to the rear and the front edge should be fl ush with drawer side. Attach the slides
with three #6 x 5/8" Undercut (type 17) Screws (R). The slides will extend beyond the back of the
drawer. See FIGURE 8.
9) Attach a Drawer Face (E) to the Drawer False Front (C). Insert the #8 x 1¼" Machine Screws (ZD)
through the center holes in the Drawer False Front and LOOSELY fasten the Knobs (TT). See
FIGURE 9. DO NOT INSERT SCREWS (S) AT THIS TIME.
Repeat the above steps with the other Drawer Faces (E) for the other drawers.
E
TT
ZC
FIG. 10A
10) Insert the left bottom drawer in the unit. Make sure that the Knobs (TT) are loose enough to allow the
Drawer Face to move freely on the Drawer False Front. Adjust the Drawer Face (E) on the Drawer
False Front (C) so that it is centered side to side, and using the Spacer (ZC), 1/8" above the top of
the Base (K). See FIGURE 10A. Tighten the Knobs (TT) to help eliminate any shifting of the Face.
Insert four #8 x 7/8" LoProfi le Screws (S) through the holes in the Drawer False Front (C) and fasten
securely. See FIGURE 10B. Repeat for the bottom right drawer.
Working your way up, repeat the above steps with each drawer. There should be a 1/8" gap between
each drawer to allow for proper functioning of the drawer slides.
11) When you have determined the location for your unit, install the Furniture Tipping Restraint (W).
Carefully follow the instructions contained on the package.
Page 8 — 586Wb — Rev. 6/07
E
V4
C
R
FIG. 9
C
S
K
TT
ZD
E
FIG. 10B
TT
S
Publicidad
