Publicidad
FIG. 6
6) With the unit lying face down, measure from top left to bottom right and from top right to bottom left.
If the unit is square, the measurements will be equal. If one is longer, tap the bottom of the side
panel on the longer side until equal. Lay the Backs (L) on the unit so that the two pieces meet and
can be fastened to the Top, the Sides, and Lower sleeper. Insert #6 x 5/8" Philtruss Antique Brass
Screws (ZG) through the pre-drilled holes in the back. See FIGURE 6.
Completely thread a Nylon Insert (ZE) on each Adjustable Glide (ZF) and fi rmly tap all the way into
the hole in bottom edge near the front of both Side Panels. Rotate the adjustable glides to level the
unit.
B
P
D
A
FIG. 7A
7) Attach two Drawer Sides (B) to one of the Drawer False Fronts (C) with #8 x 1¼" Black Screws (P)
through the pre-drilled holes in the sides. The grooves for the Drawer Bottom must line up. Slide the
Drawer Bottom (D) into the grooves. Attach the Drawer End (A) to the Sides in the same manner.
See FIGURE 7A. Repeat for the other fi ve Drawers.
Square the drawers by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest line
and squeeze them together until square. See FIGURE 7B.
ZG
ZG
ZE
C
ZG
ZG
ZF
STAIN TEST AREA
B
P
P
FIG. 7B
L
ZE
ZF
Rev. 6/07 — 586Wb — Page 7
Publicidad
