Publicidad
FIG. 2
2) Attach three Drawer Slides (Cabinet Side Left) (V2) to the front Vertical Support (X) and the Back
Vertical Support (Y) with #6 x 5/8" Undercut (type 17) Screws (R) into the pre-punched holes in the
supports. The notches in the vertical supports must be toward the bottom and face away from each
other. The slides should be fl ush with the outer edge of the vertical supports, with the wheels to the
front. See FIGURE 2.
Repeat the above steps on the opposite side of the vertical supports with the Drawer Slides (Cabinet
Side Right) (V1).
I
I
Z
X
FIG. 3A
3) Attach a Sleeper (I) to the top edge of each Vertical Support (X & Y) using a #8 x 1
(Z) in the center hole of the sleepers. There is a hole in the end of the supports for the screw. The
notches in the sleepers must face each other and the outer edges must be fl ush with the front and
back edges of the vertical supports. See FIGURE 3A.
Turn the assembly over and attach the lower sleepers in the notches of the vertical supports with
5
#8 x 1
/
" Black Screws (Z). Use the center holes in the sleepers and the pre-punched hole in the
8
notch on the supports. The notches on these sleepers must face toward the bottom of the unit. See
FIGURE 3B.
R
R
V2
X
V2
V2
Z
Y
FIG. 3B
Y
5
/
8
Rev. 6/07 — 586Wb — Page 5
Z
" Black Screw
Publicidad
