Descargar Imprimir esta página

Westinghouse WGen7500s Manual Del Usuario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRICAL
GENERATOR CAPACITY
NOTICE
capacity. Exceeding the generator's wattage/
amperage capacity can damage the generator and/
or electrical devices connected to it.
Review the Specifications for this generator and
record the running (continuous) and peak (starting)
watts. In general the higher the wattage, the more
devices can be powered at the same time. The total
power requirements of all connected devices must be
considered. Power requirements are often listed on a
device's data label or nameplate.
To determine power requirements:
l Choose the devices you want to power simultaneously.
l Record and total the running (continuous) watts of
each device. The generator must continuously produce
this amount of wattage to keep the devices running.
l Record the peak (starting) watts for each device. This is
the momentary surge of power required to start electric
motors in some tools and appliances.
l Select the device with the highest peak (starting)
wattage. Add the peak (starting) watts for that device
to the total running (continuous) watts for all the
connected devices to determine the total peak wattage
requirement for the generator.
NOTE: Total peak wattage requirement assumes
intermittent starting of devices. Adjust estimate if
devices reach peak wattage at the same time.
MANAGING GENERATOR POWER
To extend the service life of the generator, use caution
when adding electrical loads. Disconnect all loads
before starting the generator. The safest way to manage
generator power is to add loads sequentially by doing
the following:
l Remove all loads and start the generator as described
later in this manual.
l Connect and start the largest device or appliance.
Power requirements are often listed on a device's
data label or nameplate.
l Allow the generator output to stabilize. Once stable,
the engine should run smoothly and the device should
function properly.
l Connect and start the next largest device or appliance.
l Allow the generator output to stabilize.
l Repeat this process for each additional load.
10 | English
Do not overload the generator's
EXTENSION CORDS
WARNING
Extension cords running directly into the home
increase the risk of carbon monoxide poisoning
through any openings. If an extension cord running
directly into your home is used to power indoor
items, there is a risk of carbon monoxide poisoning
to people inside the home. Always use battery-
powered carbon monoxide detector (s) that meet
current UL 2034 safety standards when running the
generator. Regularly check the detector (s) battery.
WARNING
operating the generator with extension cords, make
sure the generator is located in an open, outdoor
area far away from occupied spaces with exhaust
pointed away.
WARNING
Never use worn or damaged extension cords.
Damaged or overloaded extension cords could
overheat, arc, and burn resulting in death or serious
injury.
Before connecting an AC appliance or power cord to
the generator:
l Use grounded 3-prong extension cords, tools, and
appliances, or double-insulated tools and appliances.
l Make sure the tool or appliance is in good working
order. Faulty appliances or power cords can create a
potential for electric shock.
l Make sure the electrical rating of the tool or appliance
does not exceed the rated power of the generator or the
receptacle being used.
NOTICE
capacity. Overloading the generator's wattage and/
or amperage capacity could damage connected
devices and critical generator components.
EXTENSION CORD SIZING
Make sure your extension cord can carry the required
load. Cables that are too small may cause a voltage
drop that can cause the cord to overheat or cause
property damage. Refer to the cord manufacturer's
guidelines for the appropriate size and length.
Asphyxiation
Asphyxiation hazard. When
Fire and electrocution hazard.
Do not exceed the unit's
hazard.

Publicidad

loading