Diono Radian 3R Manual Del Usuario página 16

REAR-FACING INSTALLATIONS:
5–50 lb (2.3–22.7 kg)
Infants who weigh less than 22 lb (10 kg) and are
under 1 year old, MUST use this car seat rear-facing.
Place car seat rear-facing in the vehicle back seat.
Make sure LATCH strap or vehicle seat belt is routed
through the rear-facing belt path marked with the blue
text and rear-facing illustrations.
REAR-FACING BELT PATH
Install this car seat tightly in your vehicle. The car seat
should not move at the rear-facing belt path location by
more than 1 in. (2.5 cm) from side-to-side, front-to-back.
If using a lap belt only, refer to your vehicles owners
manual for installation advice.
Harness straps MUST be at or just below the top of your
child's shoulders. Place the chest clip at armpit level.
The American Academy of Pediatrics (AAP) and NHTSA
recommend that children be rear-facing until they
reach the maximum rear-facing height and weight. This
car seat can remain rear-facing up to 50 lb (22.7 kg).
30
Radian® 3R
Rear-facing top tether is available. For rear-facing top
tether installation instructions, refer to pages 24–25.
Diono RECOMMENDS that children be rear-facing until
they reach the maximum rear-facing height and weight.
This car seat can remain rear-facing up to 50 lb (22.7 kg).
ALWAYS use rear-facing base on rear-facing installs
ONLY. DO NOT use for forward-facing or booster
mode.
DO NOT use adjustable bottom rear-facing.
diono.com
31