Diono Radian 3R Manual Del Usuario página 27

INSTALL USING LAP BELT WITH
5-POINT HARNESS : 22–65 lb (10–29.5 kg)
IMPORTANT: For harnessed
forward-facing installations using
a LAP BELT ONLY with NO top
tether anchor point available,
MUST install the Diono lap belt
cushion.
1. Unhook and remove top
tether from storage location
on back of seat.
2. Place car seat forward-facing
in back seat of the vehicle.
The entire seat bottom should
sit flat on the vehicle seat.
3. Loosely attach top tether strap.
Do not tighten. Consult vehicle's
owner manual for specific
location.
52
Radian® 3R
2
you
1 1
2
2 2
3 3
4. Slide the vehicle seat belt
through the forward-facing belt
path and out the other side.
Buckle it. The seat belt should
lie as flat as possible and not be
twisted.
5. Tighten the vehicle seat belt.
Press down firmly in the center
of the car seat. To tighten, pull
on the loose end of the vehicle
lap belt to tighten it.
6. Tighten the top tether strap.
Push the car seat back while
tightening the tether strap to
remove all the slack.
7. Test for tightness. Grab the side
of the car seat on the buckle
side with one hand where the
vehicle seat belt strap is and
slide the seat side-to-side and
front-to-back. If the seat moves
less than 1 in. (2.5 cm), it is tight
enough. Do not test by grasping
top of the car seat.
diono.com
4
3
5
5
6
6
7
7
53