Diono Radian 3R Manual Del Usuario página 20

INSTALL USING 5-POINT HARNESS WITH:
LAP BELT: 5–50 lb (2.3–22.7 kg)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 32). The entire
seat bottom should sit flat on the
vehicle seat.
2. Slide the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The vehicle seat belt
should lie flat and not be twisted.
38
Radian® 3R
3. Tighten the vehicle seat belt.
4. Test for tightness. Grab the side
1 1
2 2
Press down firmly in the center
of the car seat. To tighten, pull
on the loose end of the vehicle
lap belt.
of the car seat where the vehicle
seat belt is and slide the car seat
side-to-side and front-to-back.
If the seat moves less than 1 in.
(2.5 cm), it is tight enough. Do
not test by grasping the top or
back of the car seat.
diono.com
3
3
4
4
39