Diono Radian 3R Manual Del Usuario página 29

SECURING YOUR CHILD
INITIAL SETUP
1. Place your child in the car seat. Make sure their back
is flat against the car seat back. This can be done
in or out of the car. Avoid bulky or heavy clothing
because they will prevent the harness straps from
being tightened properly at first fitment.
2. Place harness straps over child's shoulders and
legs and buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on each
buckle tongue to make sure it is securely attached.
3. Be sure the harness straps are at the proper height.
WARNING: All harness slot positions can be
used rear-facing, however, only use the top three
shoulder harness positions for forward-facing.
REAR-FACING
Harness AT or just below
shoulders
56
Radian® 3R
FORWARD-FACING
Harness just above
shoulders
HARNESS SETUP
1. Loosen harness straps. Push down on the harness
adjuster while pulling out on the harness straps at the
chest clip. Unbuckle the chest clip and the buckle.
Place harness straps off to the sides.
2. Place your child in the seat. Make sure their back is
flat against the car seat back. Avoid bulky or heavy
clothing as they prevent the harness straps from
being tightened properly.
3. Place harness straps over child's shoulders and
legs and buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on each
buckle tongue to make sure it is properly secured.
NOTE: The addition or removal of clothing will change
the fit of the harness, especially bulky winter jackets.
Diono recommends harnessing your child first and
placing a blanket over them or putting their jacket on
backwards.
diono.com
SECURING YOUR CHILD
57