Diono Radian 3R Manual Del Usuario página 32

BELT LOCKING CLIP
WARNING: If your vehicle lap/shoulder belt is equipped
with ELR (Emergency Locking Retractor) that does
not switch to function as an ALR (Automatic Locking
Retractor), you MUST use a locking clip to secure lap
portion of vehicle seat belt. If you have any questions,
please consult your vehicle owner's manual or contact
the vehicle manufacturer.
1. Remove lock clip from back of
seat.
2. Route the vehicle seat belt
through the proper belt path
and buckle it in. While pushing
down on seat, pin the two straps
together behind the buckle tongue.
Unbuckle the belt without allowing
it to slip.
3. Attach locking clip to lap/shoulder
belt as shown. Rebuckle belt.
Check that lap belt does not move
by pulling hard. If belt loosens or
lengthens, repeat procedure.
62
Radian® 3R
1.
2. Ask the flight attendant for a "seat
3. Following the instructions in rear-facing installation
1 1
Follow the instructions in the forward-
facing installation section for use with
a lap belt.
2 2
1 in.
THIS RESTRAINT IS NOT CERTIFIED FOR USE IN
AIRCRAFT IN BOOSTER MODE.
Aircraft seats do not have shoulder belts which are
required for use with this child restraint.
3
3
REAR-FACING INSTALLATION
Adjust the seat belt buckle to
its shortest length to ensure the
buckle is accessible for release.
belt extender" and then use this
extender to adjust the seat belt length.
section for use with a lap belt to complete.
FORWARD-FACING INSTALLATION
BOOSTER INSTALLATION
diono.com
63