Diono Radian 3R Manual Del Usuario página 19

INSTALL USING LAP/SHOULDER BELT WITH
5-POINT HARNESS : 5–50 lb (2.3–22.7 kg)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 32). The entire
seat bottom should sit flat on the
vehicle seat.
2. Slide the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should lie
flat and not be twisted.
36
Radian® 3R
3. IMPORTANT!
1 1
4. Test for tightness. Grab the side
2 2
Tighten the vehicle
seat belt. Slowly pull the lap/
shoulder belt all the way out and
then let it go back in. You will
hear a clicking sound as the belt
retracts. Slowly pull out on the
belt and it should be locked. If not,
please review your vehicle owner's
manual.
Press down firmly in the center
of the car seat. To tighten, pull
from the lap/shoulder belt on the
side nearest to the buckle while
feeding the slack back into the
retractor.
of the car seat where the vehicle
seat belt is and slide the seat
side-to-side and front-to-back. If
the seat moves less than 1 in. (2.5
cm), it is tight enough. Do not test
by grasping the top or back of the
car seat.
diono.com
3
3
4 4
37