Publicidad
Idiomas disponibles
Idiomas disponibles
After connecting the battery, the initialization process takes 5 minutes. After approximately
30 seconds, the sensor LED will start flashing in 4 second intervals until the initialization is
complete. Please wait before starting the Test Run.
1. For Toilet: Sit on the toilet seat.
2. Stay there for 6 seconds or more and then leave the toilet seat. The valve should
automatically flush after 3 seconds.
3. Press the manual flushing button for 2 seconds and make sure the valve flushes
properly and the red light of the sensor is on.
4. Recheck all the pipe connections for water leaks. If the Flush Valve does not operate
properly, refer to the Troubleshooting section on p.12.
After the Flush Valve unit has been installed correctly, please explain to your customer
how to use it and tell them to observe the following instructions:
1. Do not put any object in front of the sensor window which could obstruct the sensor,
causing it to malfunction.
2. In case of any trouble, consult the troubleshooting section on p.12. If you lack the
necessary skills required or have difficulty following the directions for installation,
maintenance, repairs, troubleshooting or adjustments of the product, do not proceed
without assistance from a qualified person.
Please check your EcoPower Flush Valve at least once a month according to the
following instructions to avoid risk of property damage.
Check the piping to see whether there is any leakage.
Press the manual flushing button and make sure the
sensor red light is on for 2 seconds to see if the
generator performs properly or not.
If the red light is not on, check the generator to see if
any debris is clogged up at the turbine.
IMPORTANT! Do not scratch the sensor or faceplate when cleaning.
Avoid using any cleaning materials that may scratch the surface.
Never use polishing powder, detergent that includes coarse particles, thinners, benzene,
acids, alkaline detergents, or nylon scrub brushes.
To safely clean the surface, wipe it using a soft cloth dampened with diluted dishwashing
detergent and dry it with another soft cloth. If this does not adequately clean the surface,
wipe the area with a neutral detergent and wet cloth.
TEST RUN
NOTE TO THE INSTALLER
PERIODIC MAINTENANCE
CARE & CLEANING
- 10 -
Publicidad
