Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fitting the safety car seat (see fig. B+C+D)
! The safety car seat can be fitted either on the front
passenger seat, or on the rear seat.
! In any case it always must be positioned in a rear
facing mode (see fig. B)
! If the passenger seat is fitted with air bag, it is
compulsory to fit the safety seat on the rear seat.
(see fig. C)
· To fit the safety seat properly (see fig. B+D):
- fasten the 3 point safety harness of the car
(approved in compliance with standard ECE n˚ 16 or
equivalent) (see fig. B 1).
- place the car safety seat in the passenger seat
and lower handle in the front position (see fig. B
2): first press the buttons (see fig.D, 5). on either
side of the carrying handle and then revolve it into
position 1 (fig.D). Please make sure that the handle
is locked in position.
- insert the 3 point lap belt (see fig.B, 3).into the
seating 4 and 5 (fig. B) and the shoulder belt 6 into
the seating 7 and 8 (fig. B).
- tension the belt, paying attention that it is always
in the appropriate belt guides.
Fastening the baby (see fig. F+G)
· Place the baby into the car seat and fasten the belt
by slotting the two connectors 1 + 2 into the buckle
3 (you should hear "click') (fig. F).
· Adjust the belt by pulling the end of the belt (fig. G
1); to release the baby press the button and proceed
as shown in fig. G 2.
· The belts must be properly pulled and not twisted.
· To release the baby, press the red button 4 on the
buckle. (fig. F).
Adjusting the harness shoulder height (see fig.
H+I)
· In the car seat`s backrest there are 3 pairs of slots
which can be used to adjust the position of the shoul-
der strap according to the child`s height (fig. H).
· To change the shoulder strap height release the two
ends 1 and 2 from 3 (fig.I); fit the two straps into
the slots at the more suitable height for the child
and join the ends 1 and 2 with 3.
! The baby must always fit the safety harnesses.
(fig. H 2)
Use as a seat (see fig. D)
· The Safe2go car seat can be used as a practical
seat at home as well. Whenever you lift the car
seat by using the handle, ensure that the handle is
locked in position n˚ 2 (see fig.D)
14
Publicidad
