JVC KD-S37 Manual De Instrucciones página 38

Noise is generated.
"READING" keeps flashing on
the display.
"NO FILE" appears on the
display.
"NOT SUPPORT" appears on the
display and track skips.
Tracks/folders are not played
back in the order you have
intended.
• "CANNOT PLAY" flashes on
the display.
• "NO USB" appears on the
display.
• The unit cannot detect the
USB device.
While playing a track, sound is
sometimes interrupted.
Correct characters are not
displayed (e.g. album name).
Bluetooth device does not
detect the unit.
The unit does not detect the
Bluetooth device.
2
* For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
38 ENGLISH
Symptom Remedy/Cause
The track played back is not an MP3/WMA track. Skip to
another file. (Do not add the extension code <.mp3> or
<.wma> to non-MP3 or WMA tracks.)
• Readout time varies depending on the USB device.
• Do not use too many hierarchy or folders.
• Turn off the power then on again.
• Reattach the USB device again.
Check whether the selected folder, the connected USB
device, or the iPod/iPhone contains a playable file.
Skip to the next track encoded in an appropriate format
or to the next non-copy-protected WMA track.
The playback order is determined by the write-in time
stamp. The first track/folder written into the USB device
will be the first track/folder for playback.
• Attach a USB device that contains tracks encoded in
an appropriate format.
• Reattach the USB device again.
The MP3/WMA tracks have not been properly copied
into the USB device.
Copy MP3/WMA tracks again into the USB device, and
try again.
This unit can only display letters (upper case),
numbers, and a limited number of symbols. (
The unit can be connected with one Bluetooth mobile
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device
detects the unit, select "OPEN" on the unit to connect
the device. ( 11)
8)