Zooming; Operating Multiple Cameras With The Remote Commander - Sony BRC-H900 Manual De Instrucciones

Arrow button Movement of the
camera
Note
The setting above only changes the signal emitted from
the Remote Commander, and does not change the setting
of the camera itself. Therefore, repeat the setting for
each Remote Commander if you are using more than
one Remote Commander.
If the STANDBY lamp of the camera
flashes
When the camera is moved or turned by hand or by
external shock, the microcomputer inside the camera
may not be able to memorize the pan/tilt position
properly and the camera may stop.
To reset the pan/tilt position, press the PAN-TILT
RESET button or turn the power of the camera off, then
turn it on again.
46
GB
Pan/Tilt and Zoom Operation
Setting
L/R
DIRECTION SET
While holding down
STD
1
Press.
L/R
DIRECTION SET
While holding down
REV
2
Press.
STANDBY flashes

Zooming

Press either of the ZOOM buttons.
SLOW
T
Subject appears
farther away. W
(Wide angle) L/R
DIRECTION SET
Zooms in or out
slowly
(SLOW side)
Note
When you perform pan/tilt operation while the camera is
in the telephoto mode, the moving speed of the image on
the screen may be a little jerky.
Operating Multiple Cameras with
the Remote Commander
1
Set the IR SELECT switch on the rear of the camera
you want to operate to 1, 2 or 3.
1 2 3
2
Press the CAMERA SELECT button on the
Remote Commander that corresponds to the
number set in step 1.
CAMERA SELECT
1
FOCUS
AUTO
FAR
DATA SCREEN
You can then operate the camera(s) specified by number.
Every time you operate the camera(s) using the Remote
Commander, the CAMERA SELECT button pressed in
step 2 lights.
PAN-TILT
RESET
Subject appears
ZOOM FAST
closer.
T
(Telephoto)
W
RM-EV100
Zooms in or
out quickly
(FAST side)
IR SELECT
POWER
CAMERA
2 3
SELECT
MANUAL
NEAR
BACK LIGHT