System Menu - Sony BRC-H900 Manual De Instrucciones

PAN TILT SLOW (Slow Pan-Tilt)
You can select the maximum speed for the pan/tilt
operations.
OFF: Pan/tilt operates at a standard speed.
ON: Pan/tilt operates at a slower speed than the
standard.
RECALL MODE (Recall mode)
You can select the order for the pan/tilt/zoom operations
when the camera moves to a PRESET position.
MODE1: When the camera moves to a PRESET
position, the pan/tilt/zoom operations start at the
same time.
MODE2: When the camera moves to a PRESET
position, after the pan/tilt operations are finished,
the zoom operation starts.
40
GB

SYSTEM Menu

SYSTEM Menu
< S Y S T E M >
I R R E C E I V E
I M G F L I P
P A N R E V E R S E
T I L T R E V E R S E
> D I S P L A Y I N F O
S Y N C M A S T E R
H P H A S E
H P H A S E F I N E
S T E A D Y S H O T
C O L O R B A R
T A L L Y M O D E
P R E S E T M O D E
V E R S I O N
IR RECEIVE (infrared signal reception)
When it is set to OFF, the camera does not receive the
signal from the supplied Remote Commander.
Be sure to keep it ON when you use the supplied Remote
Commander.
Note
You cannot set IR RECEIVE to OFF when you operate
the menu using the supplied Remote Commander. To set
it to OFF, use the RM-BR300 Remote Control Unit (not
supplied) or the VISCA command.
IMG FLIP (image flip)
Set IMG FLIP to ON to rotate the camera image
supplied from the RGB/COMPONENT,
S VIDEO, T VIDEO, and SDI OUT connector
and the connector on the optional Interface Card inserted
into the card slot upside down and to reverse the
direction of the camera movement by pan/tilt operation.
Set PAN REVERSE to ON to reverse the horizontal
movement of the camera image.
Set TILT REVERSE to ON to reverse the vertical
movement of the camera image.
When you set IMG FLIP to ON, "Please restart system!"
appears. Turn off the power of the camera, then turn it on
again.
Notes
• Regardless of the IMG FLIP ON/OFF setting, images
shot by the camera are accumulated for the vertical
synchronization period and output from the
S VIDEO, T VIDEO, and SDI
COMPONENT,
OUT connector of the camera and the connector on the
optional Interface Card inserted into the card slot.
• When you set IMG FLIP to ON, turn off the camera,
then turn it on again, PAN REVERSE and TILT
REVERSE will be set to ON. When you set IMG FLIP
to OFF, turn the power off, then on again, PAN
REVERSE and TILT REVERSE will be set to OFF.
O N
O F F
O F F
O F F
O N
H D
0 3
0
O F F
O F F
L O W
M O D E 1
1 . 0 0
RGB/