Connecting A Video Monitor Equipped With Composite Video Or S Video Input Connector; Connecting A Video Monitor, Vtr, Etc., Equipped With Sdi Input Connector - Sony BRC-H900 Manual De Instrucciones

Connecting a Video Monitor
Equipped with Composite Video or
S Video Input Connector
1 2 3 4 5 6 7 8 9
IN VISCA RS-232 OUT
VIDEO
75-ohm coaxial
cable
to composite
video input
68
GB
Connections
1 2 3
IR SELECT
VISCA RS-422 OFF ON HD SD
RGB/COMPONENT
75
DC IN 12V
EXT SYNC IN VIDEO S VIDEO SDI OUT
to the AC adaptor
(supplied)
S VIDEO
S video connecting
cable
to S video input
Video monitor
Connecting a Video Monitor, VTR,
etc., Equipped with SDI Input
Connector
Set the HD/SD select switch on the camera to SD, and
turn on the camera. You can output the signal from the
camera by converting it into an SDI signal that conforms
to SMPTE 259M serial digital interface standards.
1 2 3
1 2 3 4 5 6 7 8 9
IR SELECT
VISCA RS-422 OFF ON HD
75
IN VISCA RS-232 OUT EXT SYNC IN VIDEO S VIDEO
HD SD
DVCAM, etc., equipped with an
SDI input connector
You can change an image size (aspect ratio) of the
signals output from the SDI OUTPUT connector. For
details, see "VIDEO OUT Menu" on page 42.
SD
RGB/COMPONENT
DC IN 12V
SDI OUT
to the AC adaptor
(supplied)
SDI OUTPUT
Connecting cable
with BNC connectors
to SDI input