Publicidad
Idiomas disponibles
Idiomas disponibles
English
A
5
B
Up to three starting points (5) can be specified
on a guide wire (4). The robot mower can move
specifically to the respective starting point and
start mowing from there.
The mowing area can be divided into several
zones (example: A and B) by the guide wire (4).
The zones are defined by a starting point (5).
The robot mower can be directed from the selec‐
ted starting point to the left or right into the
desired zone. The robot mower can then mow
specifically in the selected zone. The starting
points and zones are managed in the MYiMOW
app and can be taking into account in the mow‐
ing plan.
If there is a confined section (6) in the mowing
area, the robot mower navigates the confined
area, provided that a particular minimum width is
maintained between the perimeter wires. If the
minimum distance cannot be maintained, a guide
wire (7) must be routed through the confined
section (6). The guide wire (7) then guides the
robot mower directly through the confined sec‐
tion (6) to a starting point (8). From the starting
point (8), the robot mower can mow the mowing
area behind the confined section (6). The fre‐
quency at which the robot mower returns to the
starting point (8) can be managed by the MYi‐
®
MOW
app and taken into account in the mow‐
ing plan.
60
6 Preparing the Mowing Area and Robot Mower for Operation
4
6
7
8
6
Preparing the Mowing Area
and Robot Mower for Oper‐
ation
6.1
Planning and preparing mow‐
ing areas
Plan and prepare the mowing area prior to com‐
missioning the robot mower. This enables a
robust installation and smooth operation and
eliminates potential sources of faults.
Planning mowing surfaces
► Familiarize yourself with the descriptions
about the docking station and wire routing in
the following sections.
► Transfer the information to your own garden:
– Outline of the mowing area
– Position of the docking station
– Routing of the perimeter wire (note descri‐
bed distances to the edges and wire routing
cases)
®
– Routing of the guide wire(s) (at least one,
maximum of three)
Preparing mowing areas
► Remove any objects lying around.
► Remove metals, magnetic materials and mate‐
rials that conduct electricity as well as old
perimeter wires.
► Mow lawns with a lawn mower to the cutting
height that will later be set for the operation of
the robot mower. The default setting for the
cutting height on the robot mower is a = 6 cm.
► Level out holes and rough, uneven patches.
► Where ground is hard and dry, slightly moisten
the mowing area to make driving the anchor‐
ing stakes easier.
a
0458-012-9801-A
Publicidad
