Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
INSTALLING THE WHEELS
See Figure 4.
l Place the pressure washer on a flat surface.
l Lift the rear of the pressure washer high enough to gain
access to the bottom of the frame.
l Place props beneath the pressure washer to serve as a
temporary support.
l Locate the axles, wheels, washers, and hitch pins.
l Insert an axle through the middle of a wheel, washer,
and the frame as shown.
l Push a hitch pin into the axle until the center of the pin
rests against the top of the axle.
l Repeat these steps to install second wheel.
ATTACHING THE CORD RETAINER
See Figure 5.
l Align the holes in the cord retainer with the holes in the
frame.
NOTE: Install the cord retainer facing up as shown.
l Insert a bolt through the frame and the cord retainer.
Tighten to secure.
INSTALLING THE HANDLE
See Figure 6.
CAUTION
to the frame, use caution to avoid pinching your
fingers or hands.
FIG. 4
D
C
A - Axle
B - Wheel
C - Washer
D - Hitch Pin
When attaching the handle
B
l Slide the handle onto the frame until it contacts the
buttons.
l Depress the buttons and continue sliding the handle
down into place.
l Pull the handle up until the buttons snap into the
holes in the handle.
NOTE: Make sure the handle is secure before
operation.
FIG. 5
A
A - Cord Retainerr
B - Bolt
FIG. 6
A
A - Handle
B - Button
A
B
B
B
English | 11
Publicidad
