Thermo Scientific Sensititre AIM Instrucciones De Uso página 19

C
To start inoculation of a specific section, press in the center of the section for inoculation.
D Reset plate icon.
Gram-positive identification oil overlay icon (This icon will only be displayed if the oil
E
overlay option is enabled; refer to the instrument configuration section for further details).
Gram-negative identification oil overlay icon (This icon will only be displayed if the oil
F
overlay option is enabled; refer to the instrument configuration section for further details).
3. If the oil overlay option is enabled (See maintenance and configuration section) then you will
notice 2 additional icons displayed the right hand side of the screen. Once the identification
section has been inoculated; the oil overlay can be selected. Insert a test tube containing mineral
oil and a dosing head onto the AIM system and select the oil overlay required for the specific
plate type.
A Oil overlay for the GPID plate (Gram-positive).
B Oil overlay for the GNID plate (Gram-negative).
Remove the test tube/dosing head combination from the AIM system within 30 seconds of dosing
a plate and store inverted in a rack or discard.
Inoculation of small section plates
For plates with a number of small sections it is not easy to accurately select the required section with your
finger. Therefore, functionality has been adapted to allow a greater amount of control in selecting the
correct section.
1. The section that is ready to be inoculated is highlighted in blue. To select a different section to
inoculate, touch the section required and/or use the blue arrow buttons located at the bottom of
the screen.
2. Once the target section is highlighted, press the start icon to start the inoculation of the section.
Sensititre AIM™ Instructions for Use
The picture can't be
displayed.
A
The picture can't be
displayed.
B
19