Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not force the trimmer head into uncut grass.
•
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
DANGER
AREA
9.7
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (1) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the motor running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9.8
CHANGE TO THE EDGING MODE
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Loosen the screws.
3. Push on the rotating handle latches and turn the trimmer
head 180 degrees until the trimmer head locks into
position.
1
4. Release rotating handle latches (1).
5. Insert the screws into the shaft.
6. Tighten the screws.
DIRECTION OF
ROTATION
BEST CUTTING AREA
NOTE
English
10
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SPOOL
1. Push the tabs on the sides of the trimmer head at the same
time.
9
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
EN
Publicidad
