Publicidad
Idiomas disponibles
Idiomas disponibles
f)
Do not overestimate your capabilities. Maintain body balance and equilibrium
at all times during operation. This allows for better control of the machine in
unexpected situations.
g)
Do not wear loose clothing or jewelry. Keep hair, clothing, and gloves away
from moving parts. Loose clothing, jewelry, or long hair can be caught in
moving parts.
h)
The product is not a toy. Children should be watched to ensure that they do
not play with the appliance.
i)
Keep the material to be processed free from contamination.
j)
Do not touch moving parts or accessories during operation of this machine.
2.3.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b)
Keep unused equipment out of the reach of children and anyone unfamiliar
with the device or this manual. Products are dangerous when used by
inexperienced users.
c)
Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
return the device for repair before use.
d)
Keep the product out of the reach of children.
e)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
f)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
g)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
h)
Clean the device regularly to prevent permanent dirt build-up.
i)
Do not process two workpieces at the same time.
j)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
k)
Do not tamper with the device to alter its performance or design.
l)
Do not overload the device.
m) Long elements must be supported and positioned steadily during cutting.
n)
Do not touch the blades when operating the device.
o)
Do not keep hands closer than 20 cm from the blades of the product when
holding the processed element.
p)
Regularly check and tighten the screws if necessary.
Publicidad
