MSW Motor Technics MSW-HS-F1000 Manual De Instrucciones página 22

To set the blade clearance:
On both sides, loosen the table fixing screws (a), the table locking
•
screws (b), and the large table clamping screws (c).
• Adjust the gap between the table and the blade (using the feeler
gauge (d; not supplied) set to 0.05 mm) by moving the table in the
appropriate direction (c).
• After adjusting the clearance, tighten all previously released
screws (a + b + c).
3.3.2 Adjusting the cutting head
If the cutting head is skewed after cutting, adjust its U-bolt (see the
picture below):