Publicidad
2.
it outside the side discharge chute.
3. Fit the pin
chute, so that it passes through the coils
of the spring
4. Insert the cotter pin
hole
and cause the pin to fall out
Check that the spring works
correctly and keep the side discharge
chute securely lowered. Make sure that
the pin is fitted properly to prevent
it from falling out accidentally.
IMPORTANT
For models with optional
side unloading: make sure that the side
IMPORTANT
NOTE
assembly steps in reverse order.
4.7
SIDE DISCHARGE MODELS
4.8
1.
in the holes on the
and on the side discharge
and the drilled end
in the pin
and rotate the pin
.
2.
3.
4.
5.
6.
7.
5. CONTROLS
5.1
1. Stop position.
2. Headlights On position (if
3. On position. All services
are
enabled..
4. Start position.
5.2 THROTTLE CONTROL
A. Type "I" with separate Choke
command
B. Type "II"
The positions indicated correspond to:
EN - 8
10.A
After turning the engine
.
Publicidad
