Publicidad
Idiomas disponibles
Idiomas disponibles
d) If you stop spraying material for more than an hour but less than
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
b)
Clean and maintain the unit after each use.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Latex paints should be cleaned in warm soapy water and petroleum-based
paints in mineral spirits - never the other way around!
i)
Before each use, inspect the equipment for operability and any damage.
j)
Use a soft cloth for cleaning.
k)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
l)
Do not clean the unit with fuel!
3.4.1 Cleaning the blocked spray gun
2 - pressing the trigger
•
•
3 - steady movement with trigger depressed
4 - release the trigger
•
5 - end of stroke
•
16 hours, lock the gun trigger, set the valve switch to the "Air
release/Clean" position, turn the unit off and unplug it from the
power outlet. Then slowly pour ½ cup of water on top of the paint
container to prevent it from drying out, while wrapping the gun
with a damp cloth and placing it in a plastic bag sealing it tightly.
Place everything in a darkened area. This is called short-term
storage of the unit ready for operation.
To start the unit after this time, remove the gun from the plastic
bag. Mix the paint with water. Set the valve switch to "Air
release/Clean" position and connect the unit to the power supply
and set the ON/OFF switch to ON position. Move the valve switch
to the "Spraying" position and spray on some test piece - if
everything is ok, you can continue working.
Publicidad
