MSW Motor Technics MSW-ES-1010 Manual De Instrucciones página 57

a) Lock the gun trigger and remove the spray nozzle, and immerse the
suction hose with strainer in a container of suitable cleaning solution.
b) Place a waste container next to the material container, and aim the spray
gun at the side of the material container and hold the trigger.
c) While pulling the trigger, turn on the machine and turn the valve switch
to the "Spraying" position to dispose of the spray material back into the
original container.
IMPORTANT: Throughout the next steps, keep the trigger pressed at all
times.
d) While cleaning solution starts coming out of the gun tip instead of the
spray material, direct the spray into the waste container remembering to
ground the gun e.g. by touching it against the side of the metal container.
e) As soon as clean cleaning solution starts coming out of the gun, release
the trigger.
f) Turn the valve switch to the "Air release/Cleaning" position and pull the
trigger to release the pressure from the system.
3.4.5 Cleaning the suction kit
a) Lock the gun trigger and turn off the unit.
b) Disconnect the suction and return hoses from the unit and clean them in
suitable solutions. While doing so, clean the spigot thread and the suction
set filter (see following image).
c) After cleaning the aspiration kit, connect it back to the unit and lock it.
d) Dip the end of the aspiration tube with the strainer into a bucket of fresh
cleaning solution.
e) Set the valve switch to the "Air release/Cleaning" position, then turn on
the unit and, pointing the gun tip into the waste tank, press the trigger,
allowing the pump to run for 2-3 minutes to flush it well.
f) Turn off the unit - ON/OFF switch in position "O".